Maytag RTM1500DAE Manual de usuario Pagina 2

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 16
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 1
,.STA'LAT,O--
Remove and discard cantilexer shelf packing clips _"
located just above each shelf where it hooks onto the
frame. To remove plastic dips, wiggle the clips sideways
and
pull straight out. _"
Locating Your Refrigerator tuRNLEGCLOCKWISETO
RAISE CABINET CORNER.
1. Allow a free flow of air through the t?ont base grille. TURNLEGCOUNTER-
CLOCKWISE TO LOWER
2. Your model should not be installed where tim room CABINETCORNER.
temperature will go below 55 degrees F., because it
will not run frequently enough to maintain proper _'_
temperature in the f?ceezer.
3. For ease of installation, you should leave a space of If the floor is not level and it is necessary to raise the
about 1/2 inch bee,veen the refrigerator and adjacent rear of the cabinet, we suggest rolling the rear
walls or cabinets. If the refrigerator is placed with wheels onto a piece of plywood or other shim
the hinge side against a wail, you may want to leave material.
additional space so the door can be opened x_dder. 4, To replace, center the clips in the cut-out areas and
(Refer to the installation instructions for more push in until the base grille snaps into place.
detail.)
Connecting the Appliance
Important Leveling Information
Your refi'igerator is equipped with front and back WallNING: This appliance is designe d to operate
on a nominal il.5 volt, 15 amp, 60 cyele line. There
rollers so it can be moved away from the wall for
cleaning. The front rollers are adjustable and should be should be a separate, grounded circuit serMng this
v
positioned so the refrigerator sits firmly on the floor appliance only. Do not use an extension cord.
andis level. This appliance is equipped with a three-prouged I _
TO adjust the front rollers: grounding ping for your protection against possible J _"
1. Remove the base grille by grasping the ends, lift and electrical shock hazards. It mnst be plugged into a _'I
pull out. grounding receptacle. Where a standard two-prong
wall receptacle is encountered, it is the personal
responsibili_ and obligation of the customer to have it
replaced with a properly grounded three-prong wall at_
receptacle. Do not under any circumstances, cut or
remove the third (ground) prong from tim power cord.
Do not use an adapter plug.
"2.To level the refrigerator, use a screwdriver and turn _.
roller adjusting screws cloc_vise to raise the cabinet
or counterclockwise to lower the cabinet. .,.
3, It is not necessary to lock the refrigerator in place.
However, if that is desirable, turn one or both of the
locking feet clockwise, Tbey are located near the
f?ont wheels.
PAGE 1
Vista de pagina 1
1 2 3 4 5 6 7 ... 15 16

Comentarios a estos manuales

Sin comentarios