Maytag W10254443A Guía de uso y cuidado descargar pdf (Pagina 18)

USING THE BUIET=IN TROUBLESHOOTING FEATURE

1. Press LEARN MORE 2. Select TROUBLESHOOTING

With the washer on, press LEARN MORE to access the built-in

troubleshooting feature. Use the LCD control buttons to select

TROUBLESHOOTING.

Then use the LCD control buttons to select the desired

troubleshooting topic. Use the 4 and 1_buttons to advance

through the different options.

if you experience

Washer will not run

Water leaks

First try the solutions suggested here or visit our website at www.maytag.com/help

for assistance and to possibly avoid a service call.

Possible Causes ] Solution

Door not closed completely.

START/PAUSE button not pressed

firmly or held long enough.

Household fuse is blown or circuit

breaker has tripped.

Wrong type of household fuse.

Incorrect power supply.

Fill hoses not attached tightly.

Fill hose washers missing.

Drain hose connection not correct.

Check household plumbing for leaks

or clogged sink or drain.

Door seal is dirty.

Not using HE detergent or using too

much HE detergent.

Dispenser is clogged.

Make sure the washer door is closed completely.

Press and hold the START/PAUSE button 2-5 seconds.

Check that the household fuse is intact and tight, or that the

circuit breaker has not tripped. Replace the fuse or reset

the circuit breaker. If the problem continues, call a qualified

electrician.

Use a time-delay fuse.

This washer requires a 120-volt power supply.

Check with a qualified electrician.

Tighten fill-hose connections.

Make sure all 4 fill hose washers are installed correctly.

Properly secure drain hose to drainpipe or laundry tub. Refer to

the Installation Instructions for additional information.

Do not place tape over drain opening.

Water can backup out of a clogged sink or drainpipe. Check all

household plumbing for leaks (laundry tubs, drain pipe, water

pipes, and faucets.)

Clean the door seal. See "Washer Maintenance."

Use only HE High Efficiency detergents and follow

the manufacturer's recommendations.

Remove and clean the dispenser. See "Washer Maintenance."

Other performance Refer to the built-in troubleshooting See the instructions above to access the built-in

_or operation issues feature on the washer. TROUBLESHOOTING menus using the LEARN MORE button, j

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Comentarios a estos manuales

Sin comentarios

Maytag W10254443A Guía de uso y cuidado Pagina 18

Comentarios a estos manuales

Relacionado con productos y manuales para Lavadoras Maytag W10254443A