Maytag MGR4450B Guía de usuario Pagina 8

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 16
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 7
7
Notes . . .
A properly adjusted burner with clean ports will light
within a few seconds. If using natural gas the flame
will be blue with a deeper blue inner cone.
If the burner flame is yellow or is noisy the air/gas
mixture may be incorrect. Contact a service techni-
cian to adjust. (Adjustments are not covered by the
warranty.)
With LP gas, some yellow tips on the flames are ac-
ceptable. This is normal and adjustment is not neces-
sary.
With some types of gas, you may hear a “popping”
sound when the surface burner is turned off. This is a
normal operating sound of the burner.
If the control knob is turned very quickly from HIGH
to WARM, the flame may go out, particularly if the
burner is cold. If this occurs, turn the knob to the
OFF position, wait several seconds and relight the
burner.
Refer to page 13 to adjust the WARM setting, if
needed.
The flame should be adjusted so it does not extend
beyond the edge of the pan.
Cooktop
To prevent the cooktop from discoloring or staining:
Clean cooktop after each use.
Wipe acid or sugar spills as soon as the cooktop has
cooled as these spills may discolor the porcelain.
Unlike a range with standard gas burn-
ers, this cooktop does not lift-up nor is it
removable. Do not attempt to lift the
cooktop for any reason.
Sealed Burners
The sealed burners of your range are secured to the cooktop
and are not designed to be removed. Since the burners are
sealed into the cooktop, boilovers or spills will not seep un-
derneath the cooktop. However, the burners should be
cleaned after each use. (See page 11 for cleaning directions.)
High Performance Burners
(12,000 BTU*)
(select models)
Ranges with two high speed burners have
the burners located in the right front and
left rear positions. These burners offer
higher speed cooking that can be used to
quickly bring water to a boil and for large-
quantity cooking.
* BTU ratings will vary when using LP gas.
Burner Grates
The grates must be properly positioned be-
fore cooking. Improper installation of the
grates may result in chipping of the
cooktop.
Do not operate the burners without a
pan on the grate. The grate’s porcelain
finish may chip without a pan to absorb
the heat from the burner flame.
Although the burner grates are durable,
they will gradually lose their shine and/or discolor, due to
the high temperatures of the gas flame.
POWER
BOOST
POWER
BOOST
Surface Cooking (continued)
Vista de pagina 7
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios