Maytag MGR8674AB0 Instrucciones de operaciones descargar pdf (Pagina 2)

INSTALLATION INSTRUCTIONS

PLEASE READ ._11Installation Instructions and Requirements Before Installing.

1, REMOVESHIPPINGBASE

NOTE; DO NOT LOWER OR RAISETHE WASHER BYTHE STEP ___ INSTALL WATER FILL HOSES

BACKGUARD.

a. Position corner posts on floor as shown (step one).

b. Carefully lay washer on its back on top of the corner posts. _'_1

NOTE: A small amount of water may run from the pump due

to factory tests.

c. Pop plastic loose from screw located between the back feet, WATER

or remove screw entirely with a _," Hex Head Nutdriver. CONNECTIONS-- ="

d. Pull plastic base away from back feet. -..

e. Grasping plastic base on sides pull downward to release

front feet from slots and toward you to remove base. COLDWATERINLET

f. Discard base. (Base can be recycled.)

RUBBER WASHER

g. RETURN WASHER TO UPRIGHT POSITION.

WATERFILLHOSES

2. INSTALLDRAIN HOSE ,_,_,__ /

Position the Hose Clamp over the end of the Drain Hose. Push

the Drain Hose on to the Pump Outtet of the Washer. Be sure to

position the hose in the direction of the standpipe, squeeze the - _r_------_

clamp ears with pliers and move clamp toward washer so as to

clamp hose securely to pump outlet. HOTWATERINLET

3. INSTALL WATER FILL HOSE

Place a flat rubber washer in one end of each of the water fill

hoses provided, making sure the washers are pushed in tightly.

Attach the hose end with the flat washers to the water connec-

tions. Hot and cold connections are identified by H & C stamped

in the cabinet, and "HOT" printed on the hose. Tighten hose sTEP _ INSTALL DRAIN HOSE

connections by hand, until snug, and then another % turn with

DRAIN HOSE

O Y B

STEP _ REMOVE SHIPPING BASE = (ONLY,_pONETOAWASHER)

FRONT FEET BACKGUARD jf

CARTON COR OST

/ (STACKED ON EACH OTHER) _ PUMP OUTLET

T (I)CARTeN CORNER POST_

1 2 3 4

Sin comentarios

Maytag MGR8674AB0 Instrucciones de operaciones Pagina 2