Maytag TOP LOADING WASHER W10338661A Guía de uso y cuidado descargar pdf (Pagina 12)

TROU BLESH OOT[ NG

First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)

to possibly avoid the cost of a service ca[[...In U.S.A. http://www.maytag.com/he[p - In Canada www.maytag.ca

Check the following for Feet may not be in contact with the Front and rear feet must be in firm contact with floor, and washer

proper installation or floor and locked, must be [eve[ to operate properly, lam nuts must be tight against

see "Using Your the bottom of the cabinet.

Washer" section. Washer may not be [eve[.

Clicking or metallic

noises

Load could be unbalanced.

Objects caught in washer drain

system.

Gurgling or humming Washer may be draining water.

Humming Sensing light is on,

Check floor for flexing or sagging, if flooring is uneven, a 3/4"

(19 mm) piece of plywood under your washer wi[[ reduce sound.

See "[.eve[ the Washer" in Installation Instructions.

Load dry items in loose heaps evenly around basket wall.

Adding wet items to washer or adding more water to basket could

unbalance washer.

Wash smaller loads to reduce imbalance.

Do not tightly pack. Avoid washing single items.

Use Bulky cycle for oversized, non-absorbent items such as iackets

and coats.

See "Cycle Guide" and "Using Your Washer" in this Use and

Care Guide.

Empty pockets before washing. Loose items such as coins

could fail between basket and tub or may block pump.

It may be necessary to ca[[ for service to remove items.

It is normal to hear metal items on clothing such as metal snaps,

buckles, or zippers touch against the basket.

It is normal to hear the pump making a continuous humming

sound with periodic gurgling or surging as final amounts of

water are removed during the Drain & Spin cycles.

YOu may hear the hum of the sensing spins after you have started

the washer. This is normal Sensing spins wi[[ take several minutes

before water is added to the washer.

Check the following for Washer not level. Water may splash off basket if washer is not level. Check that load

proper installation: is not unbalanced or tightly packed.

Fi[[ hoses not attached tightly.

Fi[[ hose washers.

Drain hose connection.

Check household plumbing for leaks

or clogged sink or drain.

Washer not loaded as recommended.

Tighten fill-hose connection.

Make sure all four fill hose flat washers are properly seated.

Pu[[ drain hose from washer cabinet and properly secure it to

drainpipe or laundry tub.

Do not place tape over drain opening.

Water can back up out of a clogged sink or drainpipe. Check all

household plumbing for leaks (laundry tubs, drain pipe, water

pipes, and faucets.)

improper loading can cause basket to be out of alignment and

cause water to splash off tub. See "Using Your Washer" for loading

instructions.

Not enough water in

the washer

Washer won't run

or fill, washer stops

working or wash light

remains on (indicating

that the washer was

unable to fill

appropriately)

Load not completely covered in

water,

Check for proper water supply.

it is normal for some of the load to be above the water line. The

washer senses load sizes and adds correct amount of water for

optimal cleaning. See "What's New Under the Lid."

Both hoses must be attached and have water flowing to inlet valve.

Both hot and cold water faucets must be turned on.

Check that inlet valve screens have not become clogged.

Check for any [<inks in inlet hoses, which can restrict water flow.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Comentarios a estos manuales

Sin comentarios

Maytag TOP LOADING WASHER W10338661A Guía de uso y cuidado Pagina 12

Comentarios a estos manuales

Relacionado con productos y manuales para Lavadoras Maytag TOP LOADING WASHER W10338661A