
7. Select Temperature
8. Select options
Once you select a cycle, select the desired wash temperature by
turning the Temperature knob to the appropriate setting based on
your load. All rinses are tap cold.
NOTE: Always read and follow fabric care label instructions
to avoid damage to your garments.
energy. This will be cooler than your Durable garments
hot water heater setting. Heavy soils
Cool Lights
Warm water is added to assist in
soil removal and to help dissolve
Colors that bleed
or fade
Cool Darks
Warm water may be added to Dark colors that bleed
assist in soil removal and to help or fade
dissolve detergents. Light soils
,}
Cold
This is the temperature from your
faucet. If your tap cold water is very
cold, warm water may be added
to assist in soil removal and help
dissolve detergent.
Dark colors that
bleed or fade
Light soils
Select the desired cycle options. [f you are using fabric
softener, be sure to select Fabric Softener Added-Yes option.
_. Press START/Pause/Unlock
to begin wash cycle
start
pause/unLock
O hold3sec.
cancel
Press the START/Pause/Unlock button to start the wash cycle.
Filling is delayed for several minutes while load balance is
sensed. When the cycle has finished, the DONE indicator will
light. Promptly remove garments after cycle has completed to
avoid odor, reduce wrinkling, and rusting of metal hooks,
zippers, and snaps.
Unlocking the lid to add garments
If you need to open the lid to add 1 or 2 missed garments:
Press START/Pause/Unlock; the lid will unlock once the washer
movement has stopped. This may take several minutes if the load
was spinning at high speed. Then close lid and press START/
Pause/Unlock again to restart the cycle.
[f lid is [eft open for more than 1 0 minutes, the water will pump
out automatically.
Delay in water fill
Filling is delayed for 2 to 3 minutes to check for unbalanced
loads. You will hear the hum of the spin prior to filling. This is
normal operation.
Comentarios a estos manuales