Maytag TOP LOADING WASHER W10338661A Guía de uso y cuidado descargar pdf (Pagina 13)

TROU BLESH OOT[ NG

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

f First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)

to possibly avoid the cost of a service ca[[...In U.S.A. htl )://www.maytag.com/he[p - In Canada www.maytag.ca

Washer won't Fun

or fill, washer stops

working or wash light

remains on dndicafing

that the washer was

unable to fill

appropriately) (cont.)

Washer not draining/

spinning, loads

are st[[[ wet, or spin

light remains on

(indicating that the

washer was unable

to pump out water

within 10 minutes)

Check proper electrical supply.

Normal washer operation.

Washer may be tightly packed.

Not using H Edetergent or using too

much HE detergent.

Empty pockets and use garment bags

for small items.

Use a cycle with a low spin speed.

The washer may be tightly packed or

unbalanced.

Check plumbing for correct drain hose

installation. Drain hose extends into

standpipe farther than 4.5" (114 ram).

Too much detergent causing suds to

slow or stop draining and spinning.

Plug power cord into a grounded 3 prong outlet.

Do not use an extension cord.

Ensure there is power to outlet.

Reset a tripped circuit breaker. Replace any blown fuses.

NOTE: If problems continue, contact an electrician.

Lid must be closed for washer to run.

Washer will pause during certain phases of cycle. Do not interrupt

cycle.

Washer spins the dry load for 2-3 minutes before filling to

determine if load is balanced, YOu may hear the hum of the spins,

This is normal

Remove several items, rearrange load evenly in basket, and add

detergent. Close lid and press START/Pause!Unlock.

Do not add more than I or 2 additional items after cycle has

started to avoid tightly packing or unbalancing.

Only use HE detergent. Suds from regular detergents can slow or

stop the washer. Always measure detergent and follow detergent

directions based on your load requirements.

To remove suds, cancel cycle. Select RINSE & SPIN. Press START/

PausejUn[ock. Do not add more detergent.

Small items may have been caught in pump or between basket

and tub, which can slow draining.

Cycles with lower spin speeds remove less water than cycles

with high spin speeds. Use the recommended cycle/speed spin for

your garment. To remove extra water in the load, select Drain &

Spin. Load may need to be rearranged to allow even distribution of

the load in the basket.

Tightly packed or unbalanced loads may not allow the washer

to spin correctly, leaving the load wetter than normal. Evenly

arrange the wet load for balanced spinning. Select the Drain & Spin

cycle to remove excess water. See "Using Your Washer" for loading

recommendations.

Check drain hose for proper installation. Use drain hose form

and securely attach to drainpipe or tub. Do not tape over drain

opening. Lower drain hose if the end is higher than 96" (2.4 m)

above the floor. Remove any clogs from drain hose.

Always measure and follow detergent directions for your load. To

remove extra suds, select Rinse & Spin. Do not add detergent, j

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Comentarios a estos manuales

Sin comentarios

Maytag TOP LOADING WASHER W10338661A Guía de uso y cuidado Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para Lavadoras Maytag TOP LOADING WASHER W10338661A